Menu
Your Cart

EPMAN -Turbo Boost Elbow Adjustable Preset to 30PSI EP-CGQ226

EPMAN -Turbo Boost Elbow Adjustable Preset to 30PSI EP-CGQ226
EPMAN -Turbo Boost Elbow Adjustable Preset to 30PSI EP-CGQ226
EPMAN -Turbo Boost Elbow Adjustable Preset to 30PSI EP-CGQ226
EPMAN -Turbo Boost Elbow Adjustable Preset to 30PSI EP-CGQ226
EPMAN -Turbo Boost Elbow Adjustable Preset to 30PSI EP-CGQ226
EPMAN -Turbo Boost Elbow Adjustable Preset to 30PSI EP-CGQ226
EPMAN -Turbo Boost Elbow Adjustable Preset to 30PSI EP-CGQ226
EPMAN -Turbo Boost Elbow Adjustable Preset to 30PSI EP-CGQ226
EPMAN -Turbo Boost Elbow Adjustable Preset to 30PSI EP-CGQ226
EPMAN -Turbo Boost Elbow Adjustable Preset to 30PSI EP-CGQ226
EPMAN -Turbo Boost Elbow Adjustable Preset to 30PSI EP-CGQ226
EPMAN -Turbo Boost Elbow Adjustable Preset to 30PSI EP-CGQ226

Product in category: Exhaust System - Exhaust Manifold Adapter ,Flange & Gasket

EPMAN -Turbo Boost Elbow Adjustable Preset to 30PSI EP-CGQ226
  • Stock: In Stock
  • Model: EP-CGQ226
  • Weight: 0.05kg
$1.40
Price in reward points: 1
50 or more $1.34

You are buying on 100% Brand New of:

 

Turbo Boost Elbow ADJUSTABLE  Preset to 30PSI EP-CGQ226
 

100% brand new and high quality

Need more boost pressure?
The stock elbow allows the wastegate to open at approximately 21-22PSI dumping excess pressure.
This product will replace and upgrade your stock elbow.
In under 5 minutes, you can install this adjustable boost elbow that is already preset to 30PSI,
with the option to increase and decrease anytime you want!  

More Boost = More Power!
Fully adjustable - Easily adjusted to increase or decrease boost pressures
Comes preset to 30PSI -  I personally set each and every elbow to 30PSI during testing.
Fits For Dodge 2500 & 3500 1994-2004 with Holset HX35W, HX40W, HY35W, and the aftermarket S300
May require use of a programmer, module, or boost fooler to eliminate codes activated by higher pressure

WILL NOT FIT 2001-2002 automatic transmission with turbo P/N: 3592811
WILL NOT FIT 2004 built after 01/05/2004 due to the electronic controlled actuator

Stock Holset turbos should not be set higher than 35PSI without risk of damage.
Stock engines should not see higher than 45PSI without risk of damage.

Spec:
Thread : 1/8 NPT / (1/8''-27)
OD :0.28''(7.16mm)

Kit Includes
- 1 PC as picture

Write a review

Note: HTML is not translated!
Bad Good
Captcha